HEATIT JHSF 6-feet 120V Self Regulating Pre-Assembled Pipe Heating Cable

HEATIT JHSF 6-feet 120V Self Regulating Pre-Assembled Pipe Heating Cable


Price: CDN$ 29.99
(as of Oct 17,2020 02:56:19 UTC – Details)



Why can JHSF pipe heating cable give you a safe, healthy energy saving and durable water pipe?
The self regulating heating core continuously adjusts its heat output to the environment at every point along the heating cable, thus the overall energy cost for the season is much lower. Energy-efficient.
JHSF pipe heating cable was approved by ETL. Pre-assemble pipe heating cable make installation easy for do-it-yourselfers. The plug, thermostat, end seal, self regulating heating cable were pre-assembled. More efficient, reliable and saving money.
Self regulating heating cable: no worry about any potential fire hazard due to the overheat. More safe than other non self regulating heating cable.
JHSF can be straight-traced, spiral , or overlap. Especially for better protected the valve. It can be used on water filled plastic and metal water pipes. It will be more convenient in your job.
Each Cable consists of tough thermoplastic inner insulation, a continuous ground braid and weather resistant thermoplastic out jacket. In the connection, JHSF takes the industrial grade heat shrinkage tube technology to make the cable more durable.
How about the manufacturer? The factory meet ISO9001 standard (audit by BV)in the production process and the company take a very strict requirement on the incoming material, production process control, finish good inspection etc. Advanced product structure engineering design, good raw material, strict production process, strict internal management plus many years maneuvering experience make HISD more reliable.
Warning Never alter or cut the length of the heating cable in any way. Any alteration may result in electrical shock or fire.
Cable should not run through the building walls, ceilings or floors.
Never use metal binding to secure heating cable to pipe.

Suitable for use on plastic and metal water pipes.( including inlet pipe,drain pipe, sewer , palm tree frost protection etc). Self regulating heating cable output will adjust automatically based on the ambient temperature at each point along the cable.
Pre-assembled, easy to install. Including grounded plug with light, built in thermostat(turn the cable 37F on 50F off) and instructions. 120 volt, 3 watts/ft at 50 degrees F. Protect pipes up to 2″ in diameter. Can be used by straight, spiral and overlap.
ETL approved. 2 ft 18/3 cold lead with plug. The lowest installation temperature of this heating cable is -10 degree C. Tough XLPE as inner insulation and weather resistant PE (high-low temperature) as out jacket. Ingress Protection 65.
Testing the cable before the installation. Uncoil the cable, plug in the heating cable. Normally you can feel the slight warm on the heating cable in few minutes.

Leave a Reply